LG A005KEEN261 Manual page 33

circuit breaker
disconnect switch
CAUTION
Please turn the switch on or off by pushing the middle of the bar, where SHT31 and Ex9BP are
combined. It is forbidden to push either end side of the bar. Any improper use could damage the
product.
Connect/disconnect the wire to connector sequence
A Make sure the CB switch and the auxiliary switch are in the OFF position. If removing power
cables, check for voltage at power cable terminal.
B To remove one of the wires from its terminal, insert a small screwdriver into the rectangular hole
above the terminal.
C Apply slight pressure to the screwdriver, and at the same time pull out the wire.
C Connecting the battery pack to the inverter.
For the inverter to connect the power cable
and communication cable to the inverter.
Then, push the disconnect switch up so that it
is in the ON position.
INFO
The battery must be turned off during shipping
and storage to reduce self-discharge.
D After turning disconnect switch ON, turn on
the circuit breaker.
Installation
33
2