For Your Safety - Operating Your Side Burner - Char-Broil 463670619 Product Manual

Medallion built-in side burner
Table of Contents

Advertisement

Available languages

Available languages

FOR YOUR SAFETY - WHILE OPERATING YOUR SIDE BURN ER
W A R N I N G
For Safe Use of Your Side burner and to
Avoid Serious Injury:
• Controls and gas source or tank
in use.
• Do not let children operate or play near side burner.
• Check burner flames regularly.
• Do not use charcoal or ceramic briquets in a gas
side burner.
• Do not cover grates with aluminum foil or any other
material. This will block burner ventilation and
create a potentially dangerous condition resulting
in property damage and/or personal injury.
• NEVER attempt to light or re-light burner with
lid closed. A buildup of non-ignited gas inside a
closed side burner is hazardous.
D A N G E R
• If you see, smell or hear gas escaping, immediately
get away from the appliance and call your fire
department.
• If during operation the flames go out (You smell
gas or cannot see the flame):
1.
Turn the burner controls
2.
Open lid.
3.
Wait 5 minutes and repeat the lighting
procedure.
• If the burner goes out, gas will continue to flow
out of the burner and could accidently ignite with
risk of injury.
• Do not attempt to repair or alter the natural gas
regulator for any "assumed" defect. Any modi-
fication to this assembly will void your warranty
and create the risk of a gas leak and fire. Use only
authorized replacement parts supplied by manu-
facturer.
C A U T I O N
• Putting out grease fires by closing the lid is not
possible. Side burners are well ventilated for safety
reasons.
OFF when not
• Do not use water on a grease fire. Personal injury
may result. If a grease fire develops, turn knobs
and gas supply off.
• Do not leave side burner unattended while preheat-
ing or burning off food residue on HI. If side burner
has not been regularly cleaned, a grease fire can
occur that may damage the product.
• The best way to prevent grease fires is regular
cleaning of the side burner following instructions
on General Side burner Cleaning and Cleaning The
Burner Assembly.
OFF.
Before each use of your Side
burner:
Perform a Valve Check
• Important: Make sure gas is off at gas supply
C h e c k t h e I g n i t o r
• Turn gas off at gas supply. Press and hold electronic
Burner Flame Check
• Remove cooking grates and heat tents. Light
Turning your Side burner Off
• Turn all knobs to the
Checking the Fuel Gas Hose
• If you have converted your side burner for use with
P a ge 8
before checking valve. The knob locks in the
off position. To check valve, first push in knob and
release, knob should spring back. If knob does not
spring back, replace valve assembly before using
side burner. Turn knob to LOW position then turn
back to off position. Valve should turn smoothly.
ignitor button. "Click" should be heard and spark
seen each time between burner and electrode. See
"Troubleshooting" if no click or spark.
burners, rotate knobs from HIGH to LOW. You should
see a smaller flame in LOW position than seen on
HIGH. Perform burner flame check on side burner,
also. Always check flame prior to each use. If only
low flame is seen refer to "Sudden drop or low
flame" in the Troubleshooting Section.
OFF position. Turn gas
supply off by turning hand-wheel clockwise to a full
stop.
LP (propane) gas, check to see if hoses are cut,
worn, or kinked, Replace damaged hoses before
using your side burner. Use only replacement hose
specified by the manufacturer.
C H A RB ROI L. C OM
HIGH
LOW

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents