Char-Broil 463670619 Product Manual page 11

CARE AND MAINTENANCE OF YOUR SIDE BURNER
C l e a n i n g t h e B u r n e r A s s e m b l y
Follow these instructions to clean and/or replace parts of burner assembly or if you
have trouble igniting side burner.
1 . Turn gas off at control knob and gas supply valve.
2 . Remove cooking grate.
3 . Remove hardware securing burner.
4 . Detach electrode from burner.
NOTE: Removal/Detachment method is shown at right.
5 . Carefully lift the burner up and away from valve opening.
We suggest three ways to clean the burner tube. Use the one easiest for you.
• Bend a stiff wire (a light weight coat hanger works well) into a small
hook. Run the hook through each burner tube several times.
• Use a narrow bottle brush with a flexible handle (do not use a brass wire
brush). Run the brush through each burner tube several times.
• Wear eye protection: Use an air hose to force air into the burner tube
and out the burner ports. Check each port to make sure air comes out
each hole.
6 . Wire brush entire outer surface of burner to remove food residue and dirt.
7 . Clean any blocked ports with a stiff wire such as an open paper clip.
8 . Check burner for damage due to normal wear and corrosion, some holes may
become enlarged. If any large cracks or holes are found, replace burner.
VERY IMPORTANT: Burner tubes must re-engage valve openings. See illus-
tration below.
9 . Attach electrode to burner.
1 0 . Carefully replace burner.
1 1 . Attach burner to bracket on firebox.
1 2 . Before cooking again on side burner, perform a "Leak Test" and "Burner Flame
Check".
STEP 5: Example of a bent, stiff
wire for cleaning your burner.
STEP 10: CORRECT BURNER
TO VALVE ENGAGEMENT
Electrode
P a ge 1 1 C H A RB ROI L. C OM