HOW TO SELECT THE pULSE STEaM MODE
This function saves the amount of water used during steam ironing.
•
Check that there is water in the water tank.
•
Select the Pulse Steam Mode by pressing the Steam Mode selection button
Pulse Steam Mode can be selected with the 'Blend' to 'Linen' fabric settings.
•
A double, continuous beep sound will be heard if you press the Steam Mode selection
button
with the non-permitted fabric setting.
•
To activate the Pulse Steam Release press the Steam On/Off button
sound will be heard.
•
The iron will release steam every 2 seconds when it in this mode.
•
To de-activate the Steam Release press the Steam On/Off button
will be heard and the steam mode will stop.
BURSTS OF STEaM
This function provides an extra amount of steam to remove stubborn creases.
•
Check that there is water in the water tank.
•
Press the Bursts of Steam trigger located under the handle.
•
Steam will shoot from the holes of the soleplate into the fabric being ironed.
•
Leave 3 seconds between bursts, to allow the iron temperature to recover.
•
For stubborn wrinkles, wait a few seconds before pressing the Bursts of Steam trigger again.
Most wrinkles can be removed within three presses.
BURSTS OF STEaM IN VERTICaL pOSITION
Warning: Do not apply steam on any clothes or fabrics that are being worn by humans
or pets. The temperature of the steam is very high.
•
Check that there is water in the water tank.
•
Check that there is nothing behind the fabric that may be damaged by the steam or heat.
•
Check that pockets, turn-ups, and cuffs are empty.
•
Check that there is water in the reservoir.
•
Hold the iron between 15 and 30 centimetres away from
the garment.
•
Press the Bursts of Steam trigger.
•
Steam will penetrate into the garment removing creases.
•
Leave 3 seconds between bursts, to allow the iron
temperature to recover.
•
For stubborn wrinkles, wait a few seconds before pressing
the Bursts of Steam button again.
Most wrinkles can be removed within three presses.
Note: Only use the higher temperature setting (Blend, Wool, Cotton, Jeans & Linen) for a
better result.
It may be necessary to press the burst of steam button a few times to start this function.
. The
once, a beep
once, a beep sound