Base station
Enable registration
This feature allows you to register a DECT peripheral without keypad. Some DECT peripherals,
such as repeaters, do not have any keypad. A special menu-operated procedure is used to register
such peripherals to the base station. Also use the peripheral instructions to register it to the base
To register a DECT peripheral
Press to enter the carousel menu
Scroll to Base station and select
Press to select Enable registration
Enter the peripheral code (RC code) and press
Follow the instructions in the peripheral manual
Line settings
To change the dial mode
Press to enter the carousel menu
Scroll to Base station and select
Scroll to Line settings and select
Press to select Dial mode
Press to select Tone or scroll to
Note: this setting allows you to select pulse dialling (also called "Loop disconnect" and used in
countries without DTMF tone dialling capability or using old PABX)
54
Enable registration
Line settings
Service code settings
OK
Pulse and select
Base station
http://www.philips.com/faqs/dect