Advertisement
Quick Links
This document describes how to unpack and install any
configuration of a REO 9100 storage appliance running
Protection OS version 5.0.x software into a standard
RETMA 19" rack.
Before unpacking the unit, ensure that the area is free
from conditions that cause electrostatic discharge (ESD).
Discharge static electricity from your body by touching a
known grounded surface. Also, avoid touching pins, leads,
or circuitry.
First Things First—Activate Your Warranty!
Before installing your new unit, it is essential that you
activate your REO warranty. Technical and warranty
support are not available until this is done:
1. Go to the Overland Technical Support website at:
http://support.overlandstorage.com/
2. Using the MEMBER LOGIN, log in to the site.
NOTE:
If you are not yet a member, click the New member?
link and follow the instructions. It's free!
Preparing REO 9100 for Installation
IMPORTANT: Overland recommends that you install the
unit in a clean, controlled environment where the air is
free from dust as possible.
Because of its weight when loaded with disk drives, each
REO 9100 array ships in two boxes. Box One contains:
• REO 9100 appliance
• Rail kit and hardware
• Hardware bag (8 washers, 2 clip nuts, & 2 screws)
• Four power cords
• REO 9100 Documentation CD
• This quick start guide
Installing REO 9100 in 19-Inch Rack
WARNING: Install units in the rack from the bottom up.
Extending a unit with empty spaces beneath it might
cause the rack to tip causing damage or injuries.
Part Number 10400144-101 11/2007
Quick Start Guide
©2007 Overland Storage, Inc.
REO™ 9100 with Protection OS™ 5.0
(E-Mail)
Figure 1. Login and Sign-up Links
3. From the menu on the left, select My Products > Add
or Register a Product, and follow the on-screen
instructions.
Box Two contains 24 numbered disk carriers, with either
12 or 24 drives installed, depending on the configuration.
CAUTION:
Overland strongly recommends that you
install power conditioning and an adequately rated
uninterruptible power supply (UPS), especially in areas
prone to blackouts, power dips, and electrical storms.
The REO is intended to be grounded. Ensure it is
connected to earth ground during normal use.
Verify the AC power to the appliance is disconnected
before you install or remove the drive carriers.
Installing the Rail Kit
The REO 9100 comes with a rail kit for mounting the
appliance in a 19-inch rack. The unit has a 5U form factor.
(Password)
1
4
Page
of
Advertisement
Related Manuals for Overland Storage REO 9100
Summary of Contents for Overland Storage REO 9100
- Page 1 Installing the Rail Kit WARNING: Install units in the rack from the bottom up. The REO 9100 comes with a rail kit for mounting the Extending a unit with empty spaces beneath it might appliance in a 19-inch rack. The unit has a 5U form factor.
- Page 2 (Figure 4) where it attaches to the bracket. 1. Install the REO 9100 in the slide rails: a. Extend fully both middle rail slides. Nut Bar Rear Bracket b.
- Page 3 3 - Data Port 1 (RJ-45) 6 - FC Port 1 9- AC Power Connectors Figure 7. REO 9100 Rear Panel Connections Once the unit is secured in the rack and the disk drives 2. Plug your LAN Ethernet connection into the installed, you are ready to attach the cables and cords: Management port (8).
- Page 4 Powering Up the REO 9100 1. Plug the power cords into an AC power source. NOTE: Your REO 9100 is now ready to be configured. You must leave the appliance ON while completing the configuration process for your application and backup servers.