Advertisement
Powering Up the REO 9100
1. Plug the power cords into an AC power source.
IMPORTANT: If the unit begins to power up BEFORE
all power cords are plugged into AC power, shut
down the appliance using the Power button on the front
of the appliance
(Figure
connected to an AC source before turning the unit ON.
2. To turn on the appliance, press and hold the Power
button
(Figure
8) for no more than one (1) second.
The System performs a power-on self-test (POST),
which takes a 2–3 minutes.
Additional Information
The REO is preconfigured to use Data Port 1 as the initial
communication mechanism for your management system.
It uses default IP address 10.0.0.1 and subnet mask
255.255.255.0.
You can connect your management system to Data Port 1
and then configure the port information via the REO GUI
(you may want to move the connection to the management
system from Data Port 1 to the Management Port after
you have completed the configuration process).
NOTE:
You cannot configure the data port to which you are
currently connected. When connected to Data Port 1, you can
configure only the Management Port or Data Port 2. To configure
Data Port 1, you must be connected to a different port.
You can get additional technical support on the Internet at http://support.overlandstorage.com, or call
1-877-654-3429 (toll-free U.S. & Canada), +44 (0) 118-9898050 (Europe), or +1 (858) 571-5555 Option 5 (International).
Part Number 10400144-101 11/2007
8). Be sure ALL power cords are
Figure 9. REO 9100 GUI Disk Management Screen
©2007 Overland Storage, Inc.
NOTE:
Your REO 9100 is now ready to be configured. You must
leave the appliance ON while completing the configuration
process for your application and backup servers.
Figure 8. Front Panel Controls and Indicators
Launching the GUI and Logging In to REO
1. In your Web browser on the management system or
laptop, enter http://10.0.0.1 to access the REO GUI.
2. Use the following default login (case-sensitive):
Logon: Administrator
Password: system
3. Because this is the first logon attempt, you must
accept the EULA to continue.
4. At the default System Summary screen, click Disk
Management
5. Verify all disks are visible and the Status is OK.
For detailed instructions on how to configure and use the
REO 9100, see the REO 9100 User Guide located on the
REO 9100 Documentation CD.
Additional Help
Power Button
(Figure
9).
4
4
Page
of
Advertisement
