HIKVISION 21 Series Quick Start Manual page 36

Table 2-1 Components
No.
1
2
3
4
5
6
7
1. Feed the plugless network cable ⑦ through the lock nut ⑥,
waterproof rubber gasket ⑤ (rubber gasket inset ridge must face
waterproof endcap), and the waterproof endcap ④ in order.
2. Crimp an RJ-45 network plug ③ onto the end of the cable, taking
care to insert the twisted pairs of wires in correct order.
3. Place the O-type gasket ② onto the end of the camera's network
interface socket ①.
4. Insert the network plug ③ into the camera's network interface
socket ①.
5. Insert the waterproof rubber gasket ⑤ into the waterproof endcap
④, and secure lock nut ⑥ with the waterproof endcap ④.
6. Align the snap on the waterproof endcap ④ with the notch on the
camera's network interface socket ①, and then secure the
waterproof endcap ④ to the camera's network interface socket ①
to finish installation.
QSG Network Dome Camera
Components
Camera's Network Interface Socket
O-Type Gasket
Network Plug
Waterproof Endcap
Waterproof Rubber Gasket
Lock Nut
Network Cable from Router/Switch
3