Gree G-TECH Series User Manual page 23

Clean and maintenance
9
Install guide louver
Hold the guide louver with the left
①
hand, hold the connection rod with
the right hand and then install the
"cross groove" at the right side of
the guide louver at the "cross clasp"
of the connecting rod.
③Press the clasps of swing blade and pull it
to the left side and then connect it with the
swing motor.
10
Install filter
Caution
Maintenance should be conducted by the professional person.
Bec ause there will be water on the guide louver and other parts during clean
operation, the unit will conduct the dry function when it's turned on for the first time.
For the first startup, the guide louver will open to the first position and then display
board will display
unit will be turned on to blow wind. Meanwhile, the display board will countdown
for a period of time. When the countdown is over, the unit will switch to operation
at the mode set by the remote controller.
Please make sure all disassembled screws are fixed well.
After being energized, if the indoor unit cannot work normally, please check the unit:
①Whether the guide louver is assembled well; ②whether the air-outlet frame is assembled
well; ③whether the blade is tightened according to the requirement; ④Whether the air
inlet is blocked by foreign objects.
Swing motor
Clasp of
swing blade
Filter
. When the display is finished, the indoor
→ → →
19
②Hold the left side connection rod with
left hand, hold the air louver with
the right hand and then assemble
the guide louver according to the
direction as shown by the figure.