Toro 41569 Installation Instructions Manual page 9

6. Disconnect the connectors under the dash between the
manual control box and the spray harness (Fig. 21).
1
3
Figure 21
1. Existing manual control
box harness
2. Spray harness
2
1
m–6399
Figure 22
1. Rear control box harness
2. T-end
3. Middle lead with eye-ring
connector and spade
connector.
2
m–6389
3. T-end of the new, rear
control box harness
3
4
4. Switch connectors
7. Connect the T-end of the new rear control box harness
between the manual control box harness and the spray
harness (Fig. 21 and 22).
8. Route the rear control box harness through the dash,
under the vehicle, through the wire harness rings, and
back to the control box (Fig. 23 and 24).
1
Figure 23
1. Wire harness rings
1
Figure 24
1. Rear control box harness routed to the control box area
9. Route the middle lead into the engine compartment and
along the front of the engine through the cable guides
securing the main wire harness.
9
m–6394
1
m–6395