Table of Contents
Advertisement
Assembling the Frame
1. Install the hose reel support to the hydraulic reservoir
mount (Fig. 2) using 2 flange-head bolts (3/8 x 1 inch)
and 2 flange nuts (3/8 inch). Do not fully tighten the
nuts to allow for adjustment later.
3
2
m–6349
Figure 2
1. Hose reel support
2. Hydraulic reservoir mount
2. Install the ends of the 2 hose reel straps to holes in the
tank saddle that you located and/or drilled earlier
(Fig. 2) using 2 flange-head bolts (3/8 x 1 inch) and
2 flange nuts (3/8 inch).
3. Attach the hose reel support to the hose reel straps
(Fig. 2) using 2 flange-head bolts (3/8 x 1 inch) and
2 flange nuts (3/8 inch).
4. Level the straps and hose reel support and then tighten
all fasteners.
5. Install the hose reel assembly onto the hose reel straps
(Fig. 3) using 4 flange-head bolts (3/8 x 1 inch) and
4 flange nuts (3/8 inch).
3
1
3. Hose reel straps
Figure 3
1. Hose reel assembly
6. Remove and discard the bolt and nut from the lower
inside roller support on the hose reel and install the
electrical box in that hole (Fig. 4), using a flange-head
bolt (5/16 x 1 inch) and a flange nut (5/16 inch).
3
m–6351
Figure 4
1. Electrical box
2. Flange-head bolt,
5/16 x 1 inch
7. Route the hose reel ground wire (plain black wire with
an eye-ring coming from the hose reel motor) behind
the hydraulic tank and forward around the frame.
8. Connect the end of the ground wire to the battery
grounding stud on the machine, located behind the
battery box and passenger seat, under the frame (Fig. 5).
3
1
m-6350
2
1
3. Flange nut, 5/16 inch
Advertisement
Table of Contents
