Table of Contents
Advertisement
19. Connect a 1/2 inch hose to the open fitting on the
control valve assembly (Fig. 18).
m–6386
Figure 18
1. Control valve assembly
20. Connect the end of the hose to the fitting on the hose
reel (Fig. 17) and secure both ends with 2 small plastic
hose clamps.
Installing the Control Switches and
Pressure Gauge
1. Wrap Teflon tape counterclockwise around the threads
of the gauge and install the reducer fitting onto the
gauge (Fig. 19).
1
2
Figure 19
1. Pressure gauge
2. Bracket (inside of the
control box cover)
1
2
2. Hose
4
5
3
m–6387
3. Nut
4. Reducer fitting
5. Black plastic fitting
2. Install the black plastic fitting into the reducer fitting on
the gauge (Fig. 19).
3. Install the pressure gauge into the bracket under the
circular opening inside the control box cover, securing
it with the nut packaged with it (Fig. 19).
Note: The face of the gauge must face the circular opening
of the cover.
4. Wrap Teflon tape counterclockwise around the threads
of the small silver fitting that is packaged with the red
tubing and install it into the port you drilled out on the
tee in front of the boom valves (Fig. 11).
5. Install the two switches into the rectangular holes on the
top of the cover (Fig. 20). Install the momentary switch
(switch that does not stay in either position when you
are not pressing it) into the hole marked with the
continuous variable and plus (+) and minus (–) signs.
Note: The small square hole on the bottom of the switches
should be oriented toward the long slot in the cover.
2
1
Figure 20
1. Control box cover
2. Toggle switch
8
3
m–6388
3. Momentary switch
Advertisement
Table of Contents
