Table of Contents
Advertisement
Description
Reducer fitting and nut
Plastic fitting, small
Control box cover
Silver fitting, small
Red tubing
Toggle switch
Momentary switch
Rear control box wire harness
Fuse, 10 amp
Flange-head bolt, 1/4 x 3/4 inch
Flange nut, 1/4 inch
Knob
Long hose with fitting, 1/2 inch dia
Plastic hose clamp, small (one extra one
included)
Preparing the Machine
1. Ensure that the machine is empty of all fluids. If
chemicals have been used in the machine, flush the
system thoroughly with clean water then drain the
water; refer to your vehicle Operator's Manual for
instructions.
2. Disconnect the negative battery terminal from the
battery.
3. On the tank saddle on the right side of the machine,
locate the third hole from the front of the machine.
Measure and mark a location on the tank saddle
2 inches (5 cm) behind the center of the 3rd hole
(Fig. 1).
Note: If a hole already exists at this location, skip to the
Assembling the Frame section.
Qty.
Use
1
1
1
1
1
1
1
Install the switches, gauge, and cover
1
1
1
1
9
4
1
1
1
Connect the spray hose
2
m-6343
1. 2 inches
4. From your mark, measure 10 inches (25 cm) rearward
and mark that location (Fig. 1).
5. Drill 2 holes (7/16 inch dia) at the marked locations,
centered vertically in the tank saddle (Fig. 1).
2
1
2
Figure 1
2. 10 inches
Advertisement
Table of Contents
