M2Module; Intended Use; Warning And Safety Notices - ACD M2Smart Series Brief Overview

24 M2Module

24.1 Intended Use

The modules of the mobile terminal serve as accessories for the M2Smart
intended exclusively for use with the mobile terminal.

24.2 Warning and Safety Notices

Please read the following warning and safety notices. They are for your safety and to ensure that the various
modules are ready to use.
Only ACD original power supplies may be used for operation of the
modules! The use of components that have not been approved can
cause the destruction of the modules or the main device.
CAUTION
Do not set the modules near heat sources (heater blowers, etc.)
and never subject them to direct solar radiation, excess quantities
of dust or shocks. Make sure that there is no stumbling hazard due
to connection cable or power supplies.
The maximum permissible ambient temperatures for the modules
CAUTION
are listed below.
Operating temperature:
Storage temperature:
The modules may not be used in areas subject to explosion.
CAUTION
Before using the modules, any connection cables must be
checked for damage. Damaged parts must be replaced. For this,
please contact ACD Elektronik GmbH.
CAUTION
Unintended use of the interfaces is forbidden.
CAUTION
To prevent overheating, the modules may not be covered during
operation.
CAUTION
The modules may only be opened by trained specialized
personnel.
CAUTION

This is a Class A device (EN55032). This device can cause radio
interference in residential areas.
In this case, the operator can be asked to take appropriate actions.
NOTE
M2Smart_Set_Kurzübersicht_Brief Overview_V1.00_de_en
®
. The included components are
-20 °C to 60 °C/-4 °F to 140 °F
-20 °C to 60 °C/-4 °F to 140 °F
41 / 50