Scanning The Picture Of The Alarm Recordings - Alarm Scan - Sony SVT-DL224 Operating Instructions Manual

Alarm Recording
Notes
• While alarm recording is in progress, other modes are
inoperable.
• After the alarm recording is completed, the VCR
returns to the condition it was in before the alarm
signal was received.
• If an alarm input is received while the VCR is in
repeat recording (see page 14), repeat recording stops
and the REPEAT REC indicator goes off. After the
tape reaches the end, the tape is rewound and the
VCR stops. The OFF indicator lights in the display
window.
When the OFF indicator lights, in order to prevent
accidental erasure of a recorded tape, timer recording
and alarm recording cannot be executed.
If any of REC r, FF ), REW 0, PLAY z is
pressed, the OFF indicator goes off.
• If another alarm is received while alarm recording is
in progress, the second alarm recording starts and the
recording duration is extended.
• If the power is interrupted while alarm recording is in
progress and restored again, the operation before the
alarm recording was made resumes.
Indicators during alarm recording
The AL indicator flashes in the display window.
The count (left digit) of the alarm recording flashes on
the monitor screen.
The alarm recording can be counted up to 999.
When the alarm function has worked 1000 times, the
count number returns to 000.
1 0 - 1 5 - 9 7 W E D 0 0 1
0 4 : 1 5 : 4 3 8
22
To Reset the Alarm Count
Press MENU RESET.
Scanning the Picture of the
Alarm Recordings — Alarm Scan
1
Turn on the power of the equipment to be used.
2
Press PAUSE/SCAN in stop mode.
The SCA lights in the display window or AL
SCAN on the monitor screen.
3
Press FF ) or REW 0.
The portions where the alarm function worked are
subsequently played back for five seconds one by
one.
Press PAUSE P to view a certain scene in still mode.
Alarm count number
(Alarm scan mode is released.)
Press STOP p, PLAY z, FF ), or REW 0 to
release alarm scan mode.
Note
If the tape reaches the end during scanning, the tape is
rewound and the unit enters the stop mode at the
beginning of the tape.
MENU RESET
1
1 H 1 2 M 0 6 S
A L S C A N
In the display window
3 2
On the monitor screen