Features - Sony TRINITRON BVM-8045QD Operation Manual

Features

COMPONENT SDI 1) input/output
SMPTE 259M/CCIR 656-III 4:2:2 serial digital signals
from digital BETACAM VTRs can be input and active
through output.
Four color systems available
The monitor can display NTSC, PAL, SECAM and
NTSC 2) signals. The appropriate color system is
4.43
selected automatically.
HR (High Resolution) Trinitron
The HR Trinitron picture tube provides a high
resolution picture. Horizontal resolution is more than
450 TV lines at the center of the picture.
Beam current feedback circuit
The built-in beam current feedback circuit assures
stable white balance.
Comb filter
When NTSC video signals are received, a comb filter
activates to increase the resolution, resulting fine
picture detail without color spill or color noise.
Multiple input signals
In addition to the composite video signals and the Y/C
signals, analog RGB signals and component signals
can be input.
External sync input
When the EXT SYNC button is pressed, the monitor
can be operated on the sync signal fed through an
external sync connector.
Blue only picture
Black and white apparent picture consisting from only
the blue signal will be displayed. This facilitates the
"chroma" and "phase" adjustment, and the observation
of the video noise.
16:9 selector
The monitor can display the 16:9 signal with the
correct ratio of width and height, compressing the
picture vertically.
..........................................................................................................................................................................................................
1) SDI: Serial Digit Interface
2) An NTSC signal is used for playing back NTSC-recorded video cassettes with a video tape recorder/player especially
4.43
designed for use with this system.
3) Trinitron is a trademark of Sony Corporation.
2
(GB)
Under scan mode
The monitor can display signals that are scanned
outside the normal screen so you can monitor the
whole image.
Automatic/Manual DEGAUSS
The screen is automatically demagnetized when the
monitor is turned on. Manual degauss is also available
by pressing the DEGAUSS button.
® 3) picture tube
Automatic termination
(only terminals with
The Y/C, VIDEO IN and EXT SYNC IN connectors
are terminated at 75 ohms inside, when no cable is
connected to the loop-through output connectors.
When a cable is connected to an output connector, the
75-ohm termination is automatically released.
EIA standard 19-inch rack mounting
By using an MB-520 mounting bracket (not supplied),
the monitor can be mounted in an EIA standard 19-
inch rack. For details on mounting, see the instruction
manual of the MB-520.
mark)