Precautions - Toyota TVSS IV-S Installation Instructions Manual

RAV4

PRECAUTIONS

• Be sure to disconnect the negative (-)
lead from the battery terminals.
• Do not pinch the rear wiring or harness
in the tightened part.
• When passing the wires through the
bulkhead or other panels, use a
grommet to ensure waterproofing.
• Protect the wiring with tape when it is
passed through a hole.
• When disconnecting the connectors,
be sure to grip the connector body.
Do not tug on the wiring.
• Do not forcibly pull any car wiring harness.
Rough tugging may result in opened con-
nections, or a broken wire or harness.
• Confirm that lamps, horn, wiper and
other car accessories operate normally.
• Protect your car with wing covers,
seat and so on.
06-00
PLEASE READ THOROUGHLY THESE PRECAUTIONS
BEFORE THE TVSS INSTALLATION
waterproof - O.K. !!
Grommet
Taping
Stop it !
RAV4 (RHD) - 2
• Use the correct tool when tightening
bolts or nuts.
• Before drilling a hole, check that the rear
of the mounting wall is clear.
• Be sure to firmly tighten connectors
and terminals.
• Before connecting the power wiring to
the battery, check the wiring con-
nections, harness, etc. to see that they
are properly secured.
• Check body and trim near area of installation to be certain no
dirt or scratches resulted from the installation.
TVSS IV-S/-D
Insert completely