Tripp Lite PDUMH16HV Owner's Manual page 4

Installation
2
Input Power Cord Connection. Insert the
IEC 320 C19 connector
cord into the IEC 320 C20 inlet
PDU. Connect the other end of the input
power cord C to a compatible source of AC
power. The PDU should be provided with
over-current protection.
Note: The AC power source should not share
a circuit with a heavy electrical load (such as
an air conditioner or refrigerator).
2-1
Input Cord Retention (Optional). Install the
included bracket with the supplied #6-32
screws then attach the included power
A
cord to the PDU by inserting the IEC
connector B of the power cord into the IEC
power inlet C located near the end of the
PDU. Use a supplied screw
power cord connection.
Note: As an alternative, a user-supplied
power cord can be attached to the PDU by
connecting it to the IEC inlet. Do not attempt
to attach a user-supplied power cord unless
it is certified to be compatible with the input
power source that will be used by the PDU.
3
Attach equipment to the PDU. Do not exceed
the load rating of the PDU. The total
electrical current used by the PDU will be
displayed on the digital meter in amperes.
14-04-276-93331C.indb 4
A of the input power
of the
B
2
D to secure the
2-1
3
4
B
A
C
D
A
B
C
5/19/2014 2:01:47 PM