Stuart SBH CONC/1 Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Stuart Manuals
  4. Laboratory Equipment
  5. SBH CONC/1
  6. Instructions for use manual

Stuart SBH CONC/1 Instructions For Use Manual

Sample concentrator
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

Sample Concentrator
SBH CONC/1
Instructions for use

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SBH CONC/1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Stuart SBH CONC/1

Summary of Contents for Stuart SBH CONC/1

  • Page 1 Sample Concentrator SBH CONC/1 Instructions for use...
  • Page 2 General Description The Stuart sample concentrator, when used in conjunction with a Stuart block heater accelerates the evaporation process of samples of solution for analysis. With the heat generated from the block heater and the steady flow of gas above the surface of the sample, to carry away evaporated products, the rate of sample concentration is significantly increased.
  • Page 3 Gas pressure should not exceed 2 psi at the inlet valve of the gas chamber. Position your Stuart block heater on the base board, locating the two pins on the bottom of the block heater onto the two location spigots on the base board.
  • Page 4 On completion switch off the gas flow and raise the chamber out of the way. Take care the needles may be hot at this point. Operation of your Stuart block heater will be detailed in the manual supplied with it, if further...
  • Page 5 Maintenance & Servicing Periodically clean the instrument using a damp cloth and mild detergent solution. Do not use harsh or abrasive cleaning agents. Carriage Friction The carriage works by means of a friction drive. To allow for wear the friction pressure can be increase by tightening the four screws at the back of the carriage.
  • Page 6 The following spares and accessories are available from your laboratory dealer. Description Catalogue Number F7209 Needles, 76mm (pack of 100) F7210 Needles, 127mm (pack of 100) FSC4NCS Needles, 76mm PTFE coated (pack of 100) FSC4NCL Needles, 127mm PTFE coated (pack of 100) 6101609 Base board 6101608...
  • Page 7 Thank you for reading this data sheet. For pricing or for further information, please contact us at our UK Office, using the details below. UK Office Keison Products, P.O. Box 2124, Chelmsford, Essex, CM1 3UP, England. Tel: +44 (0)330 088 0560 Fax: +44 (0)1245 808399 Email: sales@keison.co.uk...

Table of Contents