Troubleshooting And Problem Solving; Overview; Initial Start-Up Problems; Faulty Power Cords - Seagate 5005 Series Hardware Installation And Maintenance Manual

5

Troubleshooting and problem solving

These procedures are intended to be used only during initial configuration, for the purpose of verifying that hardware
setup is successful. They are not intended to be used as troubleshooting procedures for configured systems using
production data and I/O.
NOTE: For further troubleshooting help after setup, and when data is present, see seagate.com/support-home.

Overview

The enclosure system includes a Storage Enclosure Processor (SEP) and associated monitoring and control logic to
enable it to diagnose problems with the enclosure's power, cooling, and drive systems. Management interfaces allow for
provisioning, monitoring, and managing the storage system.
IMPORTANT: See

Initial start-up problems

Faulty power cords

Check that you have correctly cabled the system. Contact your supplier for replacements if:
• Power cables are missing or damaged.
• Plugs are incorrect.
• Power cables are too short.

Computer does not recognize the enclosure system

1. Verify that the interface cables from the enclosure to the host computer are fitted correctly.
2. Verify that the drive carrier modules have been correctly installed.
3. Check any visible SAS indicators (RBOD, EBOD, and HBA).
4. Check HBA BIOS for SAS target visibility.
5. Verify that the operating system device driver has been installed correctly.
NOTE: If the enclosure fails initialization, see

LEDs

LED colors are used consistently throughout the enclosure and its components for indicating status:
• Green: good or positive indication
• Blinking green/amber: non-critical condition
• Amber: critical fault
82 Troubleshooting and problem solving
"Fault isolation methodology" (page 91) when conducting system diagnostics.
"If the enclosure does not initialize" (page 93).