Accessories; Operating Instructions - Challenge SS20CSDRI Original Instruction Manual

Accessories

50MM PH2 BITS
50MM SL6 BITS
CHARGER

Operating Instructions

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for driving in and loosening screws.
1. CHARGING THE BATTERY
A) BEFORE OPERATING
NOTE:
a) Do not use any charger other than that specifically provided for use with the
equipment.
b) If the power tool is very hot you must remove your power tool from the charger and
allow time for the battery to cool down before recharging.
c) The battery in your new tool is not charged when it leaves the plant. Therefore it
must be fully charged before using for the first time.
d) Please charge the battery to reach full or no less than half charge before storage. If
the tool will not be used for long periods of time, charge the battery every 3-6 months.
Plug the charger plug into a suitable power outlet. Next, connect the DC plug to the
Charging port (6). When charging is completed, unplug the charging, disconnect the
charger from the screwdriver. The screwdriver is now ready to be used.
Important:
When charging, the charger and power tool may become warm to the touch, this is
normal and does not indicate a problem.
WARNING: When battery charge runs out after continuous use or exposure to
direct sunlight or heat, allow time for the tool to cool down before re-charging
to achieve the full charge.
B) CHARGING PROCEDURE
Plug charger plug into a suitable power outlet and afterwards plug the DC plug into
charging port(6), the charging indicator (red) will illuminate at this time.
The charger indicator (red) will go out and the charging indicator (green) will illuminate
when charging is complete, then unplug the charging plug from the wall socket and then
the tool is ready to use.
OPERATION
1. FITTING AND REMOVING BITS
Insert the bit into the bit holder(1) and push the bit into the bits holder until fully inserted.
To remove the bit, simply pull it out of the bit holder.
8
Customer Helpline 0345 640 0800
1
1
1