Challenge SS20CSDRI Original Instruction Manual page 6

Safety Information
Important - Please read these instructions fully before starting assembly
Screw Driver Safety Warning
1. Hold power tool by insulated gripping surfaces, when performing an operation where the
fastener may contact hidden wiring. Fasteners contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the operator an electric shock.
a) Do not dismantle, open or shred cells or power tool.
b) Do not expose power tool to heat or fire. Avoid storage in direct sunlight.
c) Do not subject power tool to mechanical shock.
d) In the event of battery leaking, do not allow the liquid to come into contact with the
skin or eyes. If contact has been made, wash the affected area with copious amounts
of water and seek medical advice.
e) Seek medical advice immediately if a cell has been swallowed.
f) Do not maintain power tool on charge when not in use.
g) After extended periods of storage, it may be necessary to charge and discharge the
power tool several times to obtain maximum performance.
General Safety Warnings
WARNING Read all safety warnings and all instructions. Failure to follow the
warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
This appliance can be used by adults and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
Additional Safety Instructions For Your Battery Charger
1. Before charging, read the instructions.
2. After charging, disconnect the battery charger from the supply mains. Then remove
the chassis connection and then the battery connection.
3. Do not charge a leaking battery.
4. Do not use chargers for works other than those for which they are designed.
5. Before charging, ensure your charger is matching the local AC supply.
6. For indoor use, do not expose to rain.
7. The charging device must be protected from moisture.
8. Do not use the charging device in the open.
9. Do not short out the contacts of battery or charger.
10. Make sure the correct polarity (+/-) has been followed when charging.
11. Do not open the unit and keep out of the reach of children.
12. Do not charge the batteries of other manufactures or ill-suited models.
13. Ensure that the connection between the battery charger and battery is correctly
positioned and is not obstructed by foreign bodies.
14. Keep battery charger's slots are free of foreign objects and protect against dirt and
humidity. Store in a dry and frost-free place.
6
Customer Helpline 0345 640 0800