Valley Electronics daysy Instructions For Use Manual page 7

– WARNING: The device must not be modified.
– WARNING: Avoid using Daysy at or less than 30 cm away from other electrical
equipment, as this could result in improper operation.
– WARNING: Use of cables or equipment other than those specified in this docu-
ment may cause electrical interference or lead to failure of Daysy.
– Do not expose your Daysy to high temperatures (e.g. boiling water).
– Do not expose your Daysy to direct sunlight for long periods of time.
– Only take measurements in your mouth.
– Do not insert the measuring sensor too far into your mouth.
– Do not take measurements if the housing is broken.
– Do not take measurements if you have an injury in your mouth.
– Do not expose your Daysy to heavy mechanical loads.
– Only take measurements when the USB cable is NOT connected.
– Only charge your Daysy using a standard 5V USB port (IEC 60950-1 compliant)
with a maximum output current of 1A and a maximum power of 4.5W with a cable
shorter than 50cm. Do not take measurements with your Daysy while it is charging.
7