Page 1
CRCODE-203 Mechanical Lock Instruction and Programming Manual Before Installing: 1. Please read the instructions carefully to prevent missing important steps. *Note: Improper installations may result in damage to the lock which will void the factory warranty. 2. Please keep this Instruction Manual for future reference.
Page 2
IMPORTANT NOTICE: 1. If entered code does not work, push the “C” button followed by the code. Otherwise, it is not necessary to push the “C” button before entering the code. 2. The digits after the “C” button can be entered in any order to confuse tailgaters watching over your shoulders.
Checklist before installation Door Handing Installation Procedure Mark and Drill Door Change Door Handing Alignment post location CRCODE-203 Exploded View Latch and Spindle Installation Outside Lock Installation Inside Lock Installation Install Strike Plate Check and Adjust To Change Access Code...
Parts CAL-ROYAL CAL-ROYAL PARTS REMARKS Outside Lock Inside Lock 70mm 2 ” backset Spindle R Right Hand (Blue) or “R” Spindle L Left Hand (Red) or “L” 8-32 X ” screws 10-32 X 1 ” screws 44mm 8-32 ” screws 12-24 X 1”...
CHANGE THE LEVER HANDLE AND LATCH DIRECTION ACCORDINGLY *THE EXAMPLE IN THIS MANUAL IS A RIGHT HAND DOOR Installation Procedures use the drill the install reset code adjust right parts holes 6605 Flotilla St., Commerce, CA 90040 Tel (323) 888-6601 Fax (323) 888-6699 www.cal-royal.com...
3.2 Align hole of the strike with vertical line. Tighten strike plate using two screws provided. 6605 Flotilla St., Commerce, CA 90040 Tel (323) 888-6601 Fax (323) 888-6699 www.cal-royal.com...
2. Align hub onto the spindle and 4 screw posts through prep doors. 3. Align the mounting plate of the Outside lock and fasten with 4 screws. 6605 Flotilla St., Commerce, CA 90040 Tel (323) 888-6601 Fax (323) 888-6699 www.cal-royal.com...
6. If there is no binding of the latch or handles, the lock is reposition the strike plate slightly until the correct position is found. Re-tighten the bolts. 6605 Flotilla St., Commerce, CA 90040 Tel (323) 888-6601 Fax (323) 888-6699 www.cal-royal.com...
To Change Access Code CAL-ROYAL 1. Press current access code. 2. Turn lever 70° and hold. 3. Press the “Y” button. (“Y” button will stay pressed until code is changed) 5. Push the code change tool onto each button in turn, pushing in the buttons approximately 2mm turn counter-clockwise 180°...
To Change Access Code CAL-ROYAL 8. Press “C” and the new access code. 9. Turn the lever. The “Y” button will pop back up once the code is changed. *Before pressing the access code, make sure to press Access Code Recovery 1.
Page 14
6605 Flotilla St., Commerce, CA 90040 Tel (323) 888-6601 Fax (323) 888-6699 www.cal-royal.com...