Using The Blender - Philips HR2066/55 User Manual

5 HR2067/HR2066/HR2064/HR2061 only: close the lid.
6 Insert the measuring cup into the lid (Fig. 5).
7 To disassemble the blender, follow the instructions above in reverse order.

using the blender

1 Put the mains plug in the wall socket.
2 Turn the control knob to the required speed setting or press the ice button (Fig. 6).
See the blender table at the end of this user manual for the recommended quantities, speed settings
and processing times.
Never reach into the jar with your fingers or an object (e.g. a spatula) while the blender is
running.
Do not let the appliance run for more than 3 minutes at a time. If you have not finished
processing after 3 minutes, switch the appliance off for one minute before you let it run again.
3 Turn the control knob to the pulse setting several times if you want to process ingredients
very briefly.
Never use the pulse setting longer than a few seconds at a time.
4 Always switch the appliance off by setting the control knob to 0 before you open the lid.
tips
- To prevent spillage, do not put more than 1.5 litres of liquid in the blender jar, especially when
you are processing at a high speed. Do not put more than 1 litre in the blender jar when you
are processing hot liquids or ingredients that tend to foam.
- You can use the opening in the lid to add ingredients while the motor is running (Fig. 7).
- Do not process dry ingredients for more than 1 minute.
- Cut solid ingredients into smaller pieces before putting them in the blender jar. Do not process
a large quantity of solid ingredients at the same time. Process these ingredients in a series of
small batches instead.
- If you are not satisfied with the result when blending solid ingredients, switch the blender off and
use the pulse setting a few times to let the blender run briefly. You can also stir the ingredients
with a spatula (not while the blender is running!) or remove some of the contents of the jar and
process smaller amounts.
- To crush ice cubes put max. 5 cubes at a time in the jar and press the ice button a few times.
HR2074 only: The jar is made of glass and therefore breakable. Do not drop the jar on a hard
floor. Also avoid extreme thermal shocks. If the jar is very cold, rinse it well with lukewarm water
before pouring hot liquid into it. If the glass jar cracks, stop using it.
Filter (HR2074/HR2067/HR2066/HR2064 only)
HR2061: You can order the filter from your Philips dealer.
You can use the filter to obtain extra finely blended sauces, fresh fruit juices or cocktails. All pips and
skins will be caught in the filter.
Never fill the filter beyond its metal part.
Do not use the filter to process hot ingredients.
preparing the filter for use
1 Put the filter in the blender jar (Fig. 8).
Make sure the filter is properly fitted onto the bottom of the jar.
EnglisH
9