Neopost DS-75i Manual page 128

System stops while
inserting (stoppage at
the inserting point).
Flap not sufficiently
moistened.
10
Envelope not always
ejected from sealer.
124
Fingers not correctly
adjusted.
Inserted document
too long for used en-
velope.
Envelope throat incor-
rect.
Envelope glued in-
side.
Window not glued
properly.
Water level low.
Brushes dry.
Brushes dirty.
Moistening felt dry.
Moistening felt dirty.
Brushes worn out.
Moistening felt worn
out.
Inserted document
too big.
Document not inser-
ted deep enough.
Sealing area dirty.
Check fingers posi-
tion, adjust if needed.
Check fold settings.
Check envelope spe-
cifications.
Eliminate faulty envel-
opes.
Eliminate faulty envel-
opes.
Check water level,
refill if needed.
Check brushes, re-
place if needed by the
extra soaked set.
Check brushes, clean
if needed.
Check the moistening
felt, refill water tray if
needed.
Check the moistening
felt, clean if needed.
Replace brushes.
Replace moistening
felt.
Check fold settings,
adjust if needed.
Check adjustment of
envelope stop posi-
tion and fingers.
Clean sealing area.
Adjusting the envel-
ope insert fingers
Editing a job
Envelope Specifica-
tions
-
-
Filling the Sealing Li-
quid Reservoir on
page 65
Clean and replace
brushes
Clean and replace
brushes
Filling the Sealing Li-
quid Reservoir on
page 65
Replace or clean
moistening cloth on
page 112
Clean and replace
brushes
Replace or clean
moistening cloth on
page 112
Editing a job
Verifying the Insert
Position
Maintenance Sched-
ule on page 110