Advertisement
INSTALLATION
How to Install the Faucet
To perform installation, installer must provide G1/2˝ female supply
fittings(1), spaced 150mm apart, horizontal and not extending beyond
finished wall surface. Hot supply pipe must be located on the left.
Flush the water supply pipes thoroughly to remove any debris.
Install the two offset connectors(2) into the hot and cold supply pipes.
Use appropriate thread sealants on pipe threads.
Adjust the center-to-center distance between the connectors to
150mm and horizontal. They should extend 29mm beyond the
finished wall.
Thread the escutcheons(3) onto the connectors until they are against
the finished wall.
Insert washer seals(4) into supply nuts(5) of the faucet. Thread the
faucet supply nuts onto the connectors and tighten. When tighten the
nuts, use strap wrench or soft cloth between product and regular
wrench to protect the finish.
Insert the water flow restrictor(9) into the inlet of the handspray(10) if
needed. Connect hose(8) to the faucet outlet(7), and to the handspray
with washers(6).
How to Install the Shower Bracket
Determine a suitable location on the finished wall to install the bracket.
Mark bracket base mounting hole locations on the wall according to the
dimension. Drill two holes on the finished wall, the holes should match
the anchors(11). Install the anchors.
Tighten screws(12) to secure bracket base(13, flat side upward). Put
the bracket(14) onto the bracket base and lock by stopper.
1141292-2A-B
Cold
1
Hot
2
3
10
9
6
8
4 5
7
6
13
14
12
11
2
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tight.
Ensure that the lever handle is in the close position.
Turn on the main water supply, and check for leaks. Repair as
needed.
Remove the aerator assembly(15) and handspray. Run hot and cold
water through the faucet for about one minute to remove any debris.
Check for leaks. Remove any debris from the aerator assembly. Shut
the faucet off, and reinstall the aerator assembly and handspray.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with a clean
soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. Which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
1141292-2A-B
15
3
Advertisement
