GE IM-6 Owner's Manual And Installation Instructions page 43

ICEMAKER INSTALLATION INSTRUCTIONS N
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE ICE CUBE TRAY SHELF
1
• Remove the two screws securing the ice cube tray
to the side wall of the freezer. Remove the tray.
• There are two white plug buttons above the screw
holes. Remove these plug buttons and install them
in the two screw holes that were used to hold the
ice cube tray shelf.
• Install two Phillips head screws (14) in the holes
that the plug buttons were in, but do not screw
them all the way in. The screw heads should
extend about 1/2" (13 mm) from the side wall
of the freezer.
Plug
Buttons
Installation Instructions
Unplug the
Sharp knife
Pliers
14
C F G H J K L
2 PREPARE FOR INSTALLATION
• Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
• Remove the outlet cover with a flat-blade
screwdriver.
3 INSTALL FILL TUBE
• Cut the fill tube with foil (16) to the
(refer to the
knife or a single-edge razor blade.
• Slide the fill tube with foil (16)
onto the water tube inlet (15).
• Go to the back of the refrigerator.
On the tube side of the water
tube inlet (15) there is an
adhesive backing. Remove the
adhesive backing and slide the
tube into the hole near the top
at the back of the refrigerator.
Firmly press on the inlet to
secure it to the refrigerator.
4
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
42
or T
M N P Q R S
template on page 66) with a sharp
N
15
(Appearance may vary)
N length
16
Hole for
wire tie