GE IM-6 Owner's Manual And Installation Instructions page 15

ICEMAKER INSTALLATION INSTRUCTIONS F
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE PLUG COVER
1
Remove the electric plug cover.
To remove the type shown in Fig. 1,
insert a standard screwdriver blade
in slot at bottom of cover, apply
pressure upwards, and pry cover
away from freezer wall. Discard
this cover.
To remove the type shown in
Fig. 2, press top of cover down
to free its upper tab from slot in
freezer wall. Then pull cover
straight out to free the lower tabs
from their slots. Save this cover
for reinstallation later.
2 LOOSEN MOUNTING SCREWS
Loosen the two mounting screws (A) but do not screw
them all the way out. The screws should extend
approximately 1/2" (13 mm) out from the freezer wall.
A
Installation Instructions
Unplug the
Pliers Sharp knife
Fig. 1
Fig. 2
C F G H J K L
3 INSTALL FILL TUBE EXTENSION
• Remove and discard the white
plug from the upper left corner
of the freezer wall.
• Cut the fill tube extension (10)
to the F
template on page 67) with
F
a sharp knife or a single-edge
razor blade and slide it onto
the fill tube against the stop.
4
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave the
power switch in the OFF position until the refrigerator
is connected to the water supply to prevent
premature operation.
Power
Switch
5
POWER CORD ADAPTER
(on some models)
There is a power cord adapter (18) included with the
kit. Visually inspect to see if the power cord on the
icemaker matches the socket on the rear wall of the
freezer compartment. If needed, secure the adapter
to the side of the icemaker power cord. When
connecting the adapter to the power cord, make sure
the seal is in place between the connectors, and ensure
that both connector locks are snapped in place. Secure
the power cord adapter to the icemaker by putting it
into the hook at the back of the icemaker and attaching
it to the icemaker with a wire tie (20).
Hook
14
or T
M N P Q R S
length (refer to the
(Appearance may vary)
Seal
Remove
plug
10
F
Hole for
wire tie
Locks