GE IM-6 Owner's Manual And Installation Instructions page 21

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS G
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdrivers
REMOVE THE COVER
1
At the bottom rear of the refrigerator, remove the
screw(s) holding the compressor compartment cover
(if covered) and save for reinstallation later. Bend the
cover back for access to the compartment.
Installation Instructions
Unplug the
Pliers Sharp knife
C F G H J K L
ATTACH THE WATER VALVE
2
• Locate the female connector plug (B).
• Plug the female connector (B) onto the male
terminals on the water valve wire extension (19).
Either wire can go on either terminal.
• Plug the female connector on the water valve wire
extension (19) onto the male terminals on the
water valve (4). Either wire can go on either
terminal.
• Fasten the water valve to the cabinet edge hole
using the hex-head screw (13) from the kit.
DO NOT DRILL ANY ADDITIONAL HOLES.
• Check the plastic water line nut on the bottom of the
water valve to be sure it is hand tight. DO NOT USE
TOOLS.
20
or T
M N P Q R S
B
19
B
4
13