Restore Factory Settings; Quick Use; Introduction Of Upper Computer - Ebyte E810-DTU User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd

3.4.11 Restore factory settings

There are two ways to restore the factory settings of the module: software and hardware. In the hardware reset factory setting
mode, pull down the factory default Restore pin for 5s to 15s, and then pull it high to restore the factory settings.

4. Quick use

4.1 Introduction of upper computer

1. Search interface：
(1)Function menu area;
(2)Search device class table area.
Note: E810-TTL module supports cross network segment configuration. It is not necessary to set the PC side to be the same as
the module IP address segment during configuration. However, when performing UDP/TCP communication on a LAN, the IP address
segment must be the same, otherwise communication will fail.
Copyright ©2012–2019, Chengdu Ebyte Electronic Technology Co.,Ltd
E810-DTU(1RS1E) User Manual
15