Bahco IZO-D User Manual page 9

Setup serial baud rate:
Note: RS232 protocol is true, 8 data bits,
1 stop bit, carriage return delay is 600 mS and
character delay is 14 mS. Default is 9600 baud.
Push the ON/ZERO key to exit the setup mode
at any time without changing previous baud setup.
To change output baud rate, push and hold the
PRINT key for three seconds to enter setup
mode. Display shows previously programmed
baud rate flashing and UNITS display is off.
Use the INCREMENT and
keys to select the required baud rate,
"0012"=1200, "0024"= 2400, "0048"= 4800,
"0096"= 9600 or "0192"=19.2K.
Push the PRINT key momentarily to accept the new baud rate.
Audible alert will sound once and display will revert to measurement mode.
Maintenance/Service of all IZO torque wrenches
Clean torque wrench by wiping with a damp cloth. Do NOT use solvents,
thinners or carb cleaners. Do NOT immerse in anything. Service, repair and
calibration are to be done by BAHCO Service Centres only. Contact your
BAHCO Tools representative. Ratchet head repair can be done by BAHCO
Representative or user.
NOTE: If the display shows "Err0" at power on, the wrench is damaged and
must be returned for repair.
Battery Replacement
100% 50%
The BAHCO IZO torque wrench will automatically shut off after two
minutes sitting idle to conserve battery power.
A flashing "bAtt" display means the torque wrench is no longer accurate
and the batteries must be replaced.
Replace with three "AA" Alkaline cells only.
Remove battery when wrench is in storage.
DECREMENT
1%
GB
9