Figure 90
1. Deck-lift pedal
2. Height-of-cut pin
6.
Insert the height-adjustment pin into the 76 mm
(3 inch) height-of-cut location.
7.
Release the transport lock and allow the deck to
lower to the cutting height.
8.
On both sides of the deck, measure from the
level surface to the front tip of the blade (position
A) as shown in
Figure
Note:
The measurement should read 7.6 mm
(3 inches).
g027343
3. Transport lock
91.
1. 7.6 cm (3 inches) at
position A is correct.
2. 8.3 cm (3-1/4 inches) at
position B is correct.
9.
If needed, loosen the whizlock nut on the side
of the yoke and the jam nut on top. Fine-tune
the screw adjuster by turning it to get 7.6 cm (3
inches) height (see
Note:
To increase the height, turn the adjuster
screw clockwise; to decrease the height, turn it
counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can utilize the single-point adjustment to gain
more adjustment.
63
Figure 91
3. Measure here from the
blade tip to the hard
surface.
4. Measure at position A and
B on both sides.
Figure
92).
g024245