Table of Contents
Advertisement
[Notes]
l
l
l
l
l
[Default]
n = 0
ESC c 5 n
Enable/disable panel switches
[Name]
<1B>H<63>H<35>H< n > or <27>10<99>10<53>10< n >
[Format]
0 n 255
[Range]
Enables or disables all the panel switches.
[Description]
l
[Notes]
l
n = 0
[Default]
ESC c 6
[Reference]
Even when a paper-end detector is enabled with this com-
mand, printing is not stopped unless the corresponding paper is
selected as the print sheet.
It is possible to sheet multiple detectors for print control (to stop
printing). In this case, if only one detector detects on paper, the
printer stops printing.
Printing is stopped after the current line is completed and the
paper is fed.
When a paper-end is detected by the journal or receipt detec-
tor, the printer goes OFF-LINE after printing stops.
When a paper-end is detected by the slip detector, printing is
continued until printing on the slip sheet completes, the sheet
ejected, and the printer waits for another slip sheet to be loaded.
In addition, the detector checks for paper-end after the print and
paper feed sequence is completed. Therefore, if the actual
paper length does not correspond to the paper feed length set
by command, the printer may continue printing even after the
paper reaches its end. The user should pay attention to this.
Only the lowest bit of n is valid.
When n = < * * * * * * * 1>B, panel switches are enabled.
When n = < * * * * * * * 0>B, panel switches are disabled.
If the panel switches are disabled by this command, all the
panel switches are affected. The functions executed using the
panel switches, e.g., switching between ON-LINE and OFF-
LINE, feeding paper, etc. are disabled.
49
Advertisement
Table of Contents
