If the 24-V signal is interrupted, the safety position is set as described in chapter "Pneumatic connection (Page 25)".
Communication with the master is still possible. The "Jumper" on the basic electronics is used to activate this function. It can
be accessed after removing the module cover, and must be switched from the right position (delivery state) to the left
position.
4.2
Electrical
4.2.1
SIPART PS2 with and without HART
①
Non-hazardous area
②
Hazardous area
③
Basic electronics
Figure 4-1
Device version 2-wire
①
Non-hazardous area
②
Hazardous area
③
Basic electronics
Figure 4-2
Device version 2/3/4-wire, with connection type 2-wire
SIPART PS2 (6DR5...)
A5E03436620-AB, 01/2017
④
Binary input 1
⑤
Signal source
⑥
HART communicator
④
Binary input 1
⑤
Signal source
⑥
HART communicator
17