Front And Flat Bed Extension Covers; Front Cover; Flat Bed Extension Cover; Waste Tray - Pfaff admire air 5000 User Manual

Front and Flat Bed Extension Covers

Front Cover

Open by pushing the cover to the right as far as it will go
and then pull it toward you.
Close it again by pulling the cover upward and then slid-
ing it to the left until it locks.
Note: The front cover has a safety switch and the machine will
not sew if the front cover is open.

Flat Bed Extension Cover

Pull and swing the cover to the left to open. Swing it back
and push in place to close.
Note: The flat bed extension cover has a safety switch and the
machine will not sew if it is opened.

Waste Tray

A
The waste tray collects trimmings. Make sure the trim falls
into the tray while sewing. Empty the tray after sewing.
Place the tray along the edge of the flat bed extention (A).
Push the waste tray towards the front cover inserting the
tabs into the slit under the front cover (B). Push until it
clicks in place.
Pull the waste tray toward you to remove it.
B

Handwheel

A
By turning the handwheel you can raise and/or lower the
needles manually. Always turn the handwheel toward
B
you.
When threading, adjusting the stitch finger lever or con-
necting/disconnecting the 2-thread overlock converter,
the hand wheel should be set to locked position.
Put the "Threading/Sewing" switch in "Threading posi-
tion" (A). To lock the handwheel, match the mark on the
C
cover (B) with the mark on the handwheel (C).
8 – ABOUT YOUR MACHINE