Using A Standard Thread - Pfaff admire air 5000 User Manual

Using a Standard Thread

Set the Threading/Sewing switch to "Threading" posi-
tion (A) by turning it to the right.
Turn the handwheel slowly toward you until the mark on
the wheel matches the mark on the cover (B). The hand
wheel will click and is locked in threading position.
Thread the upper/lower looper threads up to the front of
the looper threading hole.
Prepare 12˝ (30 cm) of a standard thread and tie it 5 cm
from the end of the looper thread as shown (C).
Note: When tying the standard thread to the looper thread, tie a
knot as small as possible and cut any excess standard thread.
Using the tweezers, insert the end of the thread 2 cm or
more into the lower looper threading hole (D).
Note: Trim the thread end so that it can be inserted into the
threading hole smoothly.
Raise the looper threader lever (E) until it clicks into
place. Lower it again until it knocks into place.
Make sure that the thread comes out from the hole of the
looper tip. Carefully pull the standard thread until the
knot is about to go into the looper threader hole.
Then fold the loose end of the specialty thread as illus-
trated (F). Continue pulling the standard thread until the
specialty thread is pulled through the threading channel
and is threaded through the hole in the looper tip (G).
Set the Threading/Sewing switch to "Sewing" position.
Pull 4˝ (10 cm) of the thread under the toe of the foot, and
back between the presser fot foot and the upper cutter.
Close the front cover and lower the presser foot lifter.
A
C
E
G
B
D
F
GETTING READY TO SEW – 19