Typical Configuration - Omron XW2B-40J6-2B Connection Manual

WX2B
J TYPICAL CONFIGURATIONS
Position Control Module, Cable on the Position Control
and CQM1
Position Control Module Cable for C200H-NC112
(for one axis) for C200H
C200H-NC112
Position Control Module Cable for C200HW-NC113
(for one axis) for C200H
C200HW-NC113 XW2Z-jjjJ-A6
Position Control Module Cable for C200H-NC211
(for two axis) for C200H
C200H-NC211 XW2Z-jjjJ-A2
Position Control Module Cable for C200HW-NC213
(for two axes/four axes) (two axes) and C200HW-
for C200HW NC413 (four axes)
C200HW-NC213 XW2Z-jjjJ-A7
C200HW-NC413
(See Note 3)
CQM1 (for one/two axes) Cable for CQM1H-PLB21
CQM1H-PLB21 XW2Z-jjjJ-A3
Pulse I/O Board
Note: 1. Has the functions of the conventional XW2B-20J6-1, XW2B-40J6-2 and XW2B-20J6-3.
2. Two cables will be required on the Servo driver side if the C200H-NC211 (for two axes) is used.
3. Two cables each are required on the Position Control Terminal Block and Position Control Module side and on the Servo Driver
side if the CQM1H-PLB21 is used for two axes.
4. Two cables each will be required on the Position Control Terminal Block and Position Control Module side and on the Servo
Driver side if the C200HW-NC413 (four axes) is used.
4
Position Control Terminal
Module side
Position Control Terminal
Block for C200H-NC112
XW2Z-jjjJ-A1 XW2B-20J6-1B (See Note 1)
Position Control Terminal
Block for C200HW-NC113
XW2B-20J6-1B (See Note 1)
Position Control Terminal
Block for C200H-NC211
XW2B-40J6-2B (See Note 1)
Position Control Terminal Block
for C200HW-NC213 (two axes)
and C200HW-NC413 (four axes)
XW2B-40J6-2B (See Note 4)
(See Note 3)
Servo Terminal Unit for
CQM1H-PLB21
XW2B-20J6-3B (See Note 1)
Cable on the Servo Driver
Block
(Nee Notes 2, 3 and 4)
U-series Cable
XW2Z-jjjJ-B1
(Nee Notes 2, 3 and 4)
W-series Cable
XW2Z-jjjJ-B4
WX2B
Servo Driver
side
U-series Servo Driver
R88D-UPjjj
W-series Servo Driver
R88D-WTjjj