Table of Contents
Advertisement
3.1
Introduction
Information in this section consists of the functional and operational procedures for the CC450-0V2
Communications Controller.
differences such as no transceiver annunciators.
3.2
General Information
The CC450-0V2 Communications Controller is a compact, easy to install communications controller. It is
designed to provide RELAY and/or SIMULCAST operation for up to 4 transceivers. With these functions, the
aircraft can become an airborne repeater or a multi-frequency transmitting platform.
When used to its potential, the CC450-0V2 provides increased efficiency and reduced workload for
communication operations.
3.3
Controls and Indicators
Once the function of each switch is understood, the CC450-0V2 Communications Controllers are very
simple to operate.
A description of the specific switch function and operation is listed below.
Power
Switch
Power
Annunciator
3.3.1
Power Switch
Before powering up the CC450-0V2 put all transceiver switches in the down (inactive) position.
To turn the unit on, move the Power Switch to the up (ON) position. The Power Annunciator should light
GREEN and the RT1 and RT2 Transceiver Annunciators should flash alternately for 0.5 seconds.
May 5, 2012 Rev: 2.00
ENG-FORM: 806-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
CC450-0V2 Communications Controller
SM16 Installation and Operation Manual
Section 3.0 Operation
All derivative units operate in a similar manner, but may have minor
Mode Selection
Switch
Transceiver Switches
Transceiver Annunciators
Page 3-1
Advertisement
Table of Contents
