Assembly Step - Body Flex Sports Body Power BST800 StepTrac Owner's Manual & Parts List

Assembly STEP 1

Hardware Required Hardware Required Hardware Required
#78 Bolt (M8x20 mm)
4 pcs
#97 Spring Washer (M8)
9 pcs
NOTE BEFORE STARTING THE ASSEMBLY PROCESS :
To avoid misalignment due to over-tightening, please do not use a wrench and use only hand-tightening for now to ensure
easy assembly. Wrench-tightening should be performed after all parts are assembled to ensure all nuts, bolts, and parts are tightly se
cured before use.
With the help of an assistant, attach the Front Stabilizer (#16)
to the front of the Main Frame (#01). Secure with four Bolts
(#78), four Spring Washers (97) and four Washers (#98).
Attach the Rear Stabilizer (#15) to the rear of the Main Frame
(#01). secure with four Bolts (#112), four Spring Washers (97)
and four Washers (#98) .
Attach the Front Post (#02) to the Main Frame (#01), secure
with one Bolt (#104), one Spring Washer (97), one Washer
(#98) from the rear and two Screws (#111) from each side.
Attach the Left Slide Rail (#07) to the Main Frame (#01).
Secure with two Bolts (#106), two Arc Washers (#88), two
Nylon Nuts (#72) from the front. And two Bolts (#112),
two Arc Washers (#88), two Nylon Nuts (#72) from the rear.
Repeat the above the process on the right side of the machine.
BST800
#104 Bolt (M8x40 mm)
1 pc
#106 Bolt (M8x42 mm)
#98 Washer (M8)
9 pcs 4 pcs
#112 Bolt (M8x45 mm) #88 Arc Washer (M8)
8 pcs 8 pcs
#111 Screw (ST4.2x15 mm)
2 pcs
#72 nut M8
8 pcs
Page 7