Table of Contents
Advertisement
Assembly STEP 5
Hardware Required
Remove the four Screws (#77) that are pre-assembled on the back
of the Monitor (47), set them aside nearby.
Attach the Monitor (#47) to the bracket on the Front Post (#02),
secure with four Screws (#77).
Connect the Wire A to the Wire B as illustration on the right.
THE ASSEMBLY PROCESS IS NOW COMPLETE.
However, for your own safety, please make sure to read this
entire Owner's Manual which includes safety instructions and
warnings, as well as any safety/warning labels affixed to the
product before use.
After using, please insert the Pop-Pin (#70) to the holes on the left
Connection Joint (#14) and Left Slide Rail (#07).
BST800
#77 Screw (M5x8 mm)
#70 Pop-Pin (M8x50 mm)
4 pcs
pre-assembled
1 pc
Page 11
Hide quick links:
Advertisement
Table of Contents
