Table of Contents
Advertisement
Assembly STEP 3
Hardware Required
#79 Bolt (φ10x11xM8x12 mm)
#102 Wave Washer (1/2")
#101 D Shape Washer (1/2")
#78 Bolt (M8x20 mm)
2 pcs
2 pcs
#80 Bolt (φ10x11xM8x15 mm)
#103 Washer (M8)
2 pcs
#97 Spring Washer (M8)
2 pcs
2 pcs
2 pcs
2 pcs
Insert the Handlebar Axle (#54) through the Main Frame
(#01). Make sure the Handlebar Axle (#54) is centered. If you
encounter too much friction, try using WD40 or Vaseline as a
lubricant.
Attach two Wavy Washers (#102), Left Coupler Bar (#03)
and Right Coupler Bar(#04) to the Main Frame (#01) via the
Handlebar Axle (#54). Again, use WD40 or Vaseline to reduce
friction if needed.
Once the Left Coupler Bar (#03) and Right Coupler Bar (#04)
are correctly situated, fasten the end of the Handlebar Axle
(#54) with a D Shape Washer (#101), a Washer (#103), a
Spring Washer (#97) and a Bolt (#78) on each side.
Attach Connection Joint (#14) to the Left Couple Bar (#03),
Secure with one Bolt (#80).
Attach Connection Joint (#14) to the Left Pedal Tube (#05),
Secure with one Bolt (#79).
Repeat the above process on the right side of the machine.
3
5
BST800
Page 9
Hide quick links:
Advertisement
Table of Contents
