Installing A Board - Huawei eSpace U1900 Series Quick Installation Manual

3 Installing a Board

3a
Installing a Board
Loosen the screws on the filler panel
and use the flat-head screwdriver to
remove the filler panel.
Insert the board into the empty slot,
press the ejector lever into place,
and fasten the captive screws.
3b
Adjusting Components on the Board
If you want to use the T1 trunk, you must remove the jumper caps on the CVP
board (U1910&U1930) or MTU board (U1911&U1960&U1981).
If you want to use the built-in VMS service (U1911&U1960&U1981) or
customize the system announcements, ensure that you have installed an SD
card in slot 0 of the MTU board.
SD0 SD1
4