S6520X-26Mc-Si - H3C S6520X-SI Series Installation Manual

S6520X-26MC-SI

Figure 62 Front panel
(1) 5G/2.5G/1000/100BASE-T autosensing
Ethernet port
(3) Power module 1 status LED (PWR1)
(5) Management Ethernet port LED (LINK/ACT)
(7) Expansion card status LED (SLOT)
(9) USB port
(11) Micro USB console port
(13) Management Ethernet port
Figure 63 Rear panel
1
(1) Grounding screw
(3) Power module 1 (PWR1)
An S6520X-26MC-SI switch comes with power module slot 1 empty and power module slot 2
installed with a filler panel. You can install one or two power modules for the switch as required.
In Figure 63, two PSR75-12A AC power modules are installed in the power module slots. For more
information about installing and removing a power module, see
module."
An S6520X-26MC-SI switch comes with a filler panel in the expansion slot. You can select an
expansion card for the switch as required. In
in the expansion slot. For more information about installing and removing an expansion card, see
"Installing and removing an expansion
2
Figure
card."
51
(2) 5G/2.5G/1000/100BASE-T autosensing Ethernet
port LED
(4) System status LED (SYS)
(6) Mode LED (MODE)
(8) Power module 2 status LED (PWR2)
(10) Mode button
(12) Console port (CONSOLE)
3
(2) Expansion card
(4) Power module 2 (PWR2)
"Installing and removing a power
63, an LSWM2SP2PM interface card is installed
4