Table of Contents
Advertisement
XP SBC SC 490 14-02-2003 16:43 Pagina 11
DC12V
DC12V
OUTPUT
OUTPUT
TV
TV
DC12V
DC12V
OUTPUT
OUTPUT
TV
TV
CHANNEL
CHANNEL
A
A
B
B
C
C
D
D
3 Put the battery compartment cover back in place and tighten the screw.
> If the rechargable battery pack begins to lose its effectiveness, replace it
with a new battery pack. Use rechargeable NiMH battery packs only!
4 Connect the AC power adapter (24) to a mains socket and the cord to
the DC 12V —<± socket (22) of the docking base.
5 Place the Parent Unit inside the docking base.
Do not place the docking base against the wall.
> The battery check light (14) blinks red.
> The Parent Unit can be operated now, but you should leave it in the
docking base until the battery pack is fully charged (at least 14-16 hours).
The battery check light (14) will then light red.
> When the battery check light (14) flashes red, the battery power is low.
Place the Parent Unit inside the docking base to recharge the battery
pack.
Operating the Baby Cam
Channel selection
1 Use the CHANNEL selector (8) on the Baby Unit to select the required
channel.
2 Use the CHANNEL selector (18) on the Parent Unit to set the
Parent Unit to the same channel as the Baby Unit.
• If there is interference or if sound reception is poor, try repositioning the
units (Baby Unit first) or set both units to another channel.
Always make sure both units are set to the same channel.
ENGLISH
11
Advertisement
Table of Contents
