BMW Motorrad R 1200 GS Rider's Manual page 40

Possible cause:
3
The motorcycle's speed has not
exceeded the threshold of ap-
38
prox. 20 mph (30 km/h). The
TPC sensors do not send their
signal until after this speed has
been exceeded for the first time
( 92).
Watch TPC display at higher
speed. A permanent fault has
not occurred until the general
warning light also lights up. In
this case:
Have fault eliminated by a spe-
cialized workshop, preferably
z an authorized BMW Motorrad
retailer.
Possible cause:
There is a fault in the radio con-
nection to the TPC sensors.
Possible causes are radio sys-
tems in the surrounding area,
which interfere with the connec-
tion between the TPC control
unit and the sensors.
Watch the TPC display in an-
other environment. A perma-
nent fault has not occurred un-
til the general warning light also
lights up. In this case:
Have fault eliminated by a spe-
cialized workshop, preferably
an authorized BMW Motorrad
retailer.
Sensor defective or
system fault
General warning light lights
up yellow.
Tire symbol appears on the
display.
" " or " " is displayed.
-- -- --
Possible cause:
Wheels without installed TPC
sensors are mounted.
Retrofit wheel set with TPC
sensors.
Possible cause:
One or two TPC sensors have
failed.
Have fault eliminated by a spe-
cialized workshop, preferably
an authorized BMW Motorrad
retailer.
Possible cause:
A system fault has occurred.
Have fault eliminated by a spe-
cialized workshop, preferably
an authorized BMW Motorrad
retailer.
Battery of tire-inflation
pressure sensor weak
General warning light lights
up yellow.
appears on the display.
RDC!
This error message is only
displayed for a short time
following the pre-ride check.