Guarantee And Service; Guarantee Restrictions; Troubleshooting - Philips 4000SX/00 User Manual

Coin box or remote control unit
This appliance can also be connected to a coin box or a remote control unit.These devices may only be connected by a registered electrician.
Please note that you may only connect coin boxes or external devices that have been certified according to IEC:EN 60335-2-27, 4th edition,
clause 22.I05.
If you connect devices that do not comply with IEC:EN60335-2-27, Philips cannot be held liable for any damage and/or malfunction arising from
the use of such a device or for resulting claims, and the international Philips guarantee will no longer apply to this appliance.
The appliance and its parts may only be connected or adjusted according to the instructions in the service manual.
Environment
The lamps of the appliance contain substances that can be harmful to the environment.When you discard the lamps, make sure they are not
thrown away with the normal household waste but are handed in at an official collection point.
Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for
recycling. By doing this you will help to preserve the environment (fig. 25).
Guarantee & service
If you need service or information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips Customer
Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your
country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.

Guarantee restrictions

The following parts are not covered by the terms of the international guarantee:
- tanning lamps
- acrylic sheets
- gas springs

Troubleshooting

If problems should arise with this appliance and you are unable to solve them by means of the troubleshooting guide below, please contact the nearest Philips
service centre or the Philips Customer Care Centre in your country.
Problem
The appliance does not start
One or more fuses of the three-phase power supply
system cut off the power when you switch the
appliance on or when it is in use.
Poor tanning results
The display shows error code E01
The display shows error code E02
Cause/Solution
The mains plug has not been properly inserted into the wall socket.
The timer has not been set.
Check the fuses.The correct type is a 16A standard fuse or an automatic fuse.
You are using an extension cord that is too long and/or does not have the correct rating (16A). Consult
your dealer. Our general advice is not to use an extension cord.
Make sure users follow the tanning schedule suitable for their skin type.
When the lamps have been used for a long time, the tanning capacity will decrease.You can solve this
problem by selecting a slightly longer tanning time or by replacing the lamps.
Check if the vents of the power supply unit are open.
Stop using the appliance at once and contact your dealer or a Philips service centre.
ENGLISH
11