Table of Contents
Advertisement
Super X11SRi-IF User's Manual
2.1 Before the Installation
Be sure to read the precautions below carefully before assembling the motherboard and
components.
1. The location of the M.2 slot is on the bottom side of the motherboard. To prevent the
M.2 slot and the installed device from hitting the chassis, keep a 5.5mm clearance from
the bottom side of the motherboard and the chassis.
2. To support all the features of this motherboard, use a power supply unit with a least
500W. To support a double width add-on card on the motherboard, use a power supply
unit with at least 700W.
3. The power of this motherboard is supplied by a 12V DC-in directly. Short a wire from
PS-ON# to GND on ATX-24Pin cable plug if using an ATX power supply unit.
4. Refer to
Section 2.7 Front Control Panel
5. The devices of SATA or NVMe can be extended via a specific Supermicro cable. Refer
to the table below and contact Supuermicro for more detailed information.
Description
SATA cable
NVMe extension cable
Chapter 2
Installation
for detailed PIN definition.
Cable List
Part Number
CBL-SAST-0933 (for 4x SATA drive expansion)
CBL-SAST-0886 (for SATA power connection)
CBL-SAST-0956
20
Advertisement
Table of Contents
