Acer AN515-51 Service Manual page 267

Route the main antenna cable through the guides on the top side first, and then following with
3.
the right side of the LCD cover.
Route the eDP cable through the guides on the top side first, and then following with the left
4.
side of the LCD cover. While routing the cable, make sure to attach the mylar (closer to the
CMOS and microphone module).
Continue to route the eDP cable through the guides on the bottom left of the LCD cover. Then
5.
attach the mylar to secure the cable position.
Install the LCD panel brackets (see
6.
Service and Maintenance
Figure 5-193. Routing the Main Antenna Cable
Figure 5-194. Routing the eDP Cable
LCD Panel Brackets Installation on page 5-115).
5-129