General; Safety; Esd Guidelines - Fronius Galvo RECERBO Installation Instructions Manual

General

Safety

ESD guidelines

No guarantee or warranty claims can be made in respect of any improperly handled elec-
tronic component or PC board.
WARNING! An electric shock can be fatal. Danger due to grid voltage and DC
voltage from solar modules.
- The DC main switch is only used to switch off power to the power stage set.
Whenthe DC main switch is turned off, the connection area is still energized..
- All maintenance and service work should only be carried out when the power
stage set has been disconnected from the connection area.
- The separate power stage set area should only be disconnected from the-
connection area after first being disconnected from the grid power.
- Maintenance and service work on the inverter power stage set should only
be carried out by Fronius-trained personnel.
WARNING! An electric shock can be fatal. Danger from residual voltage from ca-
pacitors.
You must wait until the capacitors have discharged. Discharge takes 3 minutes.
CAUTION! An inadequate grounding conductor connection can cause serious in-
juries to persons and damage to (or loss of) property. The housing screws provide
an adequate grounding conductor connection for the housing ground and should
not, under any circumstances, be replaced by different screws that do not provide
a proper grounding conductor connection.
CAUTION! The inverter can be damaged by soiling or water on the terminals and
contacts of the connection area.
When removing the power stage set, make sure that terminals and contacts in the
connection area do not become soiled or wet.
Protect the wall bracket from soiling and moisture during installation.
NOTE! Observe ESD guidelines when handling electronic components and PC
boards. This primarily applies to ESD compatible
- Packaging
- Work surfaces
- Floors
- Seating
- Earthing facilities
- Handling
13